Switches in the car interior (VW Polo 4)

On right-hand drive models, the switch arrangement is slightly different from those shown in these illustrations. However, the symbols on the switches remain the same as for left-hand drive models.

1. Outdoor lighting switch

The headlights can only be turned on when the ignition is on. When the engine is started and when the ignition is turned off, the headlights automatically switch to the parking lights. Switching the headlights from low to high beam and back is done using the multi-function switch located on the left side of the steering column.

View the original article on the resource: VWmanual.ru

Note: If the exterior light is not turned off, a warning chime will sound when the ignition key is removed and the driver's door is opened.

1) On some models, when the parking lights are turned on, the low beam headlights are turned on at the same time.

Front fog lights

The front fog lights can be turned on if the switch is in the parking light or headlight position by pulling the switch towards you to the first stop.

Rear fog light

If the vehicle is equipped with a rear fog light, to turn it on, pull the light switch toward you to the second stop if the main switch is in the headlights on position.

2. Instrument panel and switch illumination

When the exterior lighting is on, turning the knob 2 to the right of the switch allows you to adjust the illumination of the instrument panel and switches.

3. Adjusting the headlight range

Depending on the vehicle's load at night, the high beam angle of the headlights may change.

This creates the risk of blinding oncoming drivers. To eliminate this drawback, the vehicle design provides the ability to adjust the headlight angle. To do this, turn the handwheel 3 to the right of the main exterior lighting switch. To lower the beam, turn the handwheel in the (-) direction, to raise the beam - in the (+) direction.