Removing
1. Unscrew the safety bolt (IN) until it stops spinning. The bolt has a safety catch and cannot be removed.
2. Unscrew the fastening bolt to the end (A). The spare wheel bracket in this case rests on the safety bolt (IN).
3. Install the wheel wrench from the on-board tool into the brackets.
4. Raise the wheel wrench slightly and move to the right. The head of the safety bolt now goes through the bracket. Swing the bracket down and remove the wheel.
Installation
1. Insert the wheel wrench into the bracket.
2. Place the spare wheel with the wheel wrench on top of the bracket, lift the bracket up and hang it on the safety bolt.
3. Remove wheel key.
4. Tighten the fastening bolt slightly first (A), then the safety bolt (IN). Then tighten both screws.
Attention! For safety reasons, only drive with a securely screwed spare wheel carrier.
Visitor comments