Note: Remove deposits in the area of the cylinders in the engine crankcase and cylinders in the cylinder head.
1. Piston pin. Removal: starting from the cylinder on the pulley side. Installation: starting from the cylinder on the flywheel side; 2. Piston. Weight difference max. 10 g. Observe markings; 3. Replace the lower rubber sealing ring of the sleeve (thick - black); 4. Replace the upper rubber (sealing ring of the sleeve (thin - green); 5. Remove and install retaining rings from the pulley side, from the flywheel side with the pistons/cylinders removed; 6. Mark cylinder liners before removal; 7. Piston rings. The joints are offset by 180°, as shown in the figure, the joint of the oil scraper ring is facing upwards.
[The original can be seen on the portal: www.VWManual.ru]
Visitor comments