Dismantling
The tank is accessible from the bottom, it is located behind the front door.
Disconnect battery from "masses".
Pump out the fuel from the tank.
Attention! Do not use open flame, flammable!
Put the car on the goats.
(20-082) remove the filling pipe 1. To do this, loosen the clamp 2 on the filling elbow and pull out the ventilation line 3.
(20-083) dismantle ventilation pipes 1, 2, and 3 on the right.
(20-084) Remove ventilation pipes 4 and 5 on the left.
(20-087) remove the suction pipe on the right from the fuel tank and the fuel outlet pipe from the fuel pump on the left.
Unscrew the protective rails from the structure and pull out their fasteners.
Lower the tank and remove the electrical wire from the fuel gauge sensor. Pull out the tank.
Installation
Insert the tank and connect the fuel gauge wire.
Insert the protective rails into the fasteners and screw them on.
Connect the fuel suction and return lines, see "Dismantling".
Install and secure the filling pipe and ventilation pipe with clamping brackets.
Fill with fuel.
Attach battery to "mass".
Visitor comments