Removal and installation the regulator valve (VW Transporter T3)

Dismantling

Drain and collect the water.

Unscrew the cover on the side of the cooling pump and remove the control valve.

Installation

Replace the seal, install the regulator, fill with coolant.

Start the engine and let it run until the regulator valve opens.

The original text is available on the portal: www.VWmanual.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Tarasov Ivan

Previous articles
Removal and installation a radiator
Radiator — design description
Replacing the coolant
Antifreeze — General Information
Cooling system hose connection diagram
Description of the design of the engine cooling system

Next articles
Checking the regulator valve
Removal and installation of the cooling pump
Removal and installation the temperature gauge sensor
Installing and dismantling the fan thermostat and checking it
Removal and installation the V-belt of the cooling pump, tensioning the belt
Cooling system circulation pump

Removal and installation the regulator valve (VW Transporter T3)

Dismantling

Installation

Visitor comments