Pic. 7.60. Poly V-belt contour 8-cyl. injection engine:
1 - pulley. V-belt transmission - three-phase generator; 2 - tension roller; 3 - V-belt pulley - crankshaft; 4 - outlet roller; 5 - V-belt pulley - air conditioning compressor; 6 - V-belt pulley - power steering vane pump; 7 - V-ribbed drive belt - three-phase generator, pulley, air conditioning compressor, power steering vane pump, crankshaft, cooling system pump and tension roller.
Removing
Remove the engine.
Loosen the V-ribbed drive belt by turning the tensioning element with a SW 19 spanner (pic. 7.61).
Lock the tensioning element with the locking pin T10060 A.
Disconnect the DF wire plug (pic. 7.62).
Remove protective cap (pic. 7.63).
Unscrew the B+ wire from the alternator (pic. 7.64).
Unscrew the fixing bolt 1 and remove the holder 2 of the cooling system pipes from the generator (pic. 7.65).
Remove the cooling system pipes 3 from the generator.
Unscrew the mounting bolts M8x90 generator (pic. 7.66).
Installation
Installation is carried out in the reverse order, paying attention to the following.
Tighten the connections to the prescribed torque.
Replace the O-rings on the coolant pipes.
Visitor comments