Removing
Disconnect the battery.
Remove soundproofing.
Open the buttons and remove the thermal insulation of the magnetic switch (pic. 7.24).
Pry off the protective caps of the fixing nuts.
Unscrew the fixing nut of the positive cable from the starter solenoid switch (pic. 7.25).
Unscrew the fixing nut of the cable terminal 50 from the starter solenoid switch (pic. 7.26).
ATTENTION: It is possible to twist the wires with a screw connection. The magnetic switch may be damaged.
ATTENTION: When loosening and tightening the positive wire and wire terminal 50, use a wrench to secure the screw connection to the magnetic switch.
Unscrew the bottom mounting bolt of the starter M 12x60 on the engine side (pic. 7.27).
Unscrew the fixing bolt 2 of the cable holder and put the cable aside (pic. 7.28).
Unscrew fixing nuts 1.
Unscrew the fastening bolt 1 of the holder of the exhaust system 2 from the engine side and remove it (pic. 7.29).
Unscrew the fixing bolt of the cooling system pipes on the engine oil pan (pic. 7.30).
Remove the upper starter mounting bolt on the gearbox side (pic. 7.31).
Remove the starter.
Installation
Installation is carried out in the reverse order, paying attention to the following.
Tighten the connections to the prescribed torque.
Visitor comments