Crankshaft (VW Lt 2d)

The crankshaft is shown in the figure 3.33. The dimensions of the crankshaft are given in Table 3.5.

Figure 3.33. Crankshaft: 1 - Oil pump drive gear; 2 - Main bearing shells 1, 2, 3, 5 and 6; 3 - Main bearing caps: 4, 7 - Bolts; 5 - Crankshaft: 6 - Crankshaft speed sensor rotor; 8 - Puller: 9, 11 - Thrust washers: 10 - 4th main bearing shell; 12 - Cylinder block.

Table 3.5. Crankshaft dimensions

Parameters	Crankshaft main journal	Crankshaft journal
Main size, mm	58.00^-0.022 _-0.042	47.80^-0.022 _-0.042
1st size rem	57.75^-0.022 _-0.042	47.55^-0.022 _-0.042
2nd size belt	57.50^-0.022 _-0.042	47.30^-0.022 _-0.042

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Checking the axial clearance of the camshaft
Compression check
Timing belt for camshaft drive
Cylinder head
Removal and installation the engine
Engine technical data

Next articles
Pistons and connecting rods
Lubrication system
Cooling system
Checking measuring and auxiliary devices
Fuel tank
Checking the boost pressure control system

Crankshaft (VW Lt 2d)

Table 3.5. Crankshaft dimensions

Visitor comments