2. Remove the horn button from the center of the steering wheel hub. Do not try to crawl under the metal socket (see photo 25.2).
Photo 25.2. Removing the horn button.
3. Disconnect the ground wire (see photo 25.3).
Photo 25.3. Ground wire of the sound signal switch.
4. Loosen the steering wheel nut.
5. Remove the wheel from the splined shaft (see photo 25.5).
Photo 25.5. Removing the steering wheel.
(The original material is available on the portal: VWMANUAL)
6. Remove the small coil spring.
7. Installation is carried out by performing the above steps in reverse order. If you have any doubts about the steering wheel alignment, check that the notch on the pinion shaft dust cover is aligned with the lug on the steering box (see Figure 11.36).
Figure 11.36. Steering alignment marks (Section 25).
8. Tighten the steering wheel nut to the required degree.
Visitor comments