2. Press "08" to select the "Read measured value block" function and confirm by pressing the "Q" key. The display should show the following information;
3. Select the desired group. Press "002" to select "Display Group 2" and confirm with "Q" The display should show the following information:
Check the accelerator pedal position in field 2. The pedal should not be pressed and the display should show 0.0%.
4. Press the pedal all the way down and observe field 2 of the display. The display should show the following information:
The percentage of pressing the accelerator pedal should increase gradually. The display should show 100%.
5. If necessary, adjust the position of the accelerator pedal 2 by turning the adjusting screw 1 so that the pedal is not pressed at idle speed (was in a free state) and the display showed a value of 0.0%, and when the accelerator pedal was fully pressed, the display showed a value of 100% (Fig. 7.40).
Visitor comments