Contents: 2.0L engine ↓ Cylinder head bolts ↓
2.0L engine
Tightening torque
| Cylinder head bolts (With a hole in the head for a polyhedron) | 75 Nm and then tighten another 90° |
Cylinder head bolts
1. Beginning in September 1979, hexagon head bolts were replaced by hexagon head bolts.
2. The bolts are tightened to the required torque (see Specifications) in the same sequence as before, and then pulled up another 90° (1/4 turn).
The original article is available on the website [www.VWManual.ru]
3. The new type bolts do not require replacement after each removal and re-tightening after the initial run.
Visitor comments