The engine compartment hood, tailgate, side doors and front fenders are bolted on and can be easily replaced. During installation, it is imperative to maintain uniform gaps between mating parts, otherwise, for example, the door may jam or increased wind noise may occur when driving. The gaps between the body parts must be the same along their entire length. The deviation of the gaps along the length of the mating is allowed by no more than 1 mm.
Attention: If, as part of body work, work is performed on the electrical system, it is imperative to disconnect the ground wire (-) from the battery. Please read the instructions in chapter «Removing and installing the battery». Work on the electrical system includes work on disconnecting/connecting electrical wires.
Note: Many covers and covers are fastened with clips. Replace damaged or missing clips with new parts. Removal and installation of expansion and locking clips is described in the corresponding chapter.
Visitor comments