Contents: Adjusting the headlight beam angle ↓ Instrument cluster and light switch…↓ Exterior lighting control switch…↓
Figure 14. Outdoor lighting control unit
To control the exterior lighting, there is a main lighting switch located on the dashboard to the left of the steering column.
The rotary handle of the light switch has the following positions:
The parking lights are on.
The low beam headlights and parking lights are on.
ABOUT The exterior lighting is off.
To turn on the fog lights, pull the handle (in this case, the headlights or parking lights must be on) on yourself until the first fixation.
To turn on the rear fog lights, depending on the vehicle's configuration, you must perform the following steps:
- cars with fog lights - pull the handle towards you until the second locking position is reached;
- cars without fog lights - pull the handle towards you until it stops.
Attention:
- fog lights should only be turned on when visibility is poor, otherwise you may blind other road users;
- when you remove the ignition key from the lock, an audible signal warns that the exterior lighting is not turned off.
Adjusting the headlight beam angle
Recommended settings for the headlight beam angle adjuster depending on the body type and vehicle load.
| Regulator position | |||
| 5-seater | 7-seater | van | |
| Driver and front passenger | 0 | 0 | 0 |
| The driver and all passengers | 1 | 2 | - |
| Fully loaded trunk | 3 | 3 | 3 |
Instrument cluster and light switch illumination
Next to the main light switch there are two knurled wheels (see figure 15) controls for the brightness of the instrument cluster backlight (1) and the angle of the headlight beam (2).
Figure 15. Lighting control panel:
1. Instrument cluster backlight brightness control
2. Headlight beam angle adjuster
Exterior lighting control switch lever
Figure 16. High beam and turn signal control switch
Switch functions:
- To turn on the high beams: With the low beams on, push the lever away from you (arrow 3). The lever will lock in this position.
- Pulse high beam activation: Pull the lever toward you (arrow 4). In this position, the lever is not locked; high beam activation is independent of low beam activation.
- To turn on the direction indicators: move the lever up (arrow 1) or down (arrow 2) with the ignition on.
- To turn on the parking lights: With the ignition off, move the lever up (arrow 1) or down (arrow 2). In this case, only the right or left side parking lights will illuminate.
Visitor comments