Constant velocity joint axle shafts (VW Polo 3)

The constant velocity joint axle shaft is shown in Fig. 9.19. The installation position for the left axle joint boot is shown in Fig. 9.20, and for the right axle joint boot - in Fig. 9.21.

Fig. 9.19. Axle shaft with constant velocity joints:
1, 12 - Retaining rings; 2 - Gasket; 3 - Inner CV joint; 4, 10 - Plate washers; 5 - Half shaft, right; 6 - Half shaft, left; 7, 9 - Clamps; 8 - Dust cover; 11 - Thrust washer; 13 - Outer CV joint; 14 - Nut; 15 - Damper; 16 - Bolt; 17 - Plate; 18 - Dust cover for inner CV joint.

(The text is copied from this portal VWmanual)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Shock absorber strut
Steering knuckle
Removal and installation the subframe
Removal and installation the lower arm
Removal, installation and inspection of the ball joint
Subframe, anti-roll bar and lower arm

Next articles
Tripod type axle shafts
Checking the inner CV joint
Checking the outer CV joint
Wheel alignment angles
Front wheel camber adjustment
Front wheel alignment adjustment

Similar articles from other manuals for VW cars:
Replacing the outer constant velocity joint Passat B5 (1996-2005)
Replacing the inner constant velocity joint (CV joint) Golf 2 (1984-1993)
Checking the oil level in the main gear of the front axle Touareg 1 (2002-2006)
Removal and installation of the drive shaft with an internal… Tiguan 1 (2007-2015)
Wheel Drive Shafts — Design Description Sharan 1 (1995-2000)
Bottom protection and preservation of axle shafts Transporter T4 (1990-2003)
Visual inspection of constant velocity joint (CV) boots Caddy 3 (2003-2010)

Constant velocity joint axle shafts (VW Polo 3)

Visitor comments