2. Reach behind the front panel, squeeze the light switch retaining lugs together and remove the switch.
Figure 12.3. Removing the light switch.
3. Remove the heater fan and hazard warning light switches in the same manner.
4. Working under the dash again, disconnect the air tubes from the heater housing.
Figure 12.9. Heater housing air tubes.
5. Remove the toolbar.
6. Disconnect the fresh air supply tubes through the hole formed after removing the instrument panel.
Figure 12.10. Fresh air hoses.
7. Remove the cover from the brake hydraulic fluid reservoir and remove the reservoir by unscrewing its single mounting screw.
Figure 12.11. Brake fluid reservoir (1). The screw is indicated by the arrow.
8. Remove the radio and speaker, if installed.
9. Loosen and remove the mounting screws from the front edge of the dash panel just below the windshield.
Figure 12.12. Front panel front mounting screws.
10. Loosen and remove the screws that secure the front panel to the body pillars.
Figure 12.13. Screws securing the front panel to the rack.
11. Working under the front edge of the front panel, remove the screws that hold it to the support brackets. Remove the front panel.
Figure 12.14. Fastening the front panel (2). Screws are indicated by arrows.
12. Installation is carried out by performing the above steps in reverse order.
Visitor comments