Removing
Bring the windshield wiper to its original position. To do this, moisten the rear window with water, switch on the wiper for a short time and switch it off using the steering column switch.
Fold up the protective cap.
Using pliers, carefully pull out the washer nozzle in the direction of the arrow.
Installation
Insert the washer nozzle into the windshield wiper arm shaft as far as it will go, so that the nozzle nozzle points vertically upwards.
Adjust the nozzle see instructions at the end of the chapter.
Fold back the protective cap.
Washer nozzle adjustment
The direction of the nozzle jet can be corrected if necessary with a pin with a diameter of 0.8 mm, eg HAZET 4850-1. To do this, insert the pin into the nozzle of the nozzle and determine the place where the jet hits on the glass.
Visitor comments