(1) Drive disk. Lightly lubricate the fine-spline profile with paste
(2) Flywheel. Check the fastening of the central studs. The surface should be free of grooves and dry
(3) Pressure plate. Check for wear and bending
(4) sealing flange
(5) O-ring. Replace
(6) Intermediate disc. Install on unloading bushings
(7) replace. Install with locking element D6
(8) Cylinder bolts*. Tighten and loosen in stages, crosswise
* hexagonal or cylindrical bolts M8x16 should be screwed in without a spring washer
Hexagonal or cylindrical bolts M8x18 should be screwed in without a spring washer
Use bolts of only one size
Attention! A clutch with a damaged or weak rivet connection must be replaced.
Visitor comments