Removing
Switch off the ignition.
Remove trims in footwell.
Remove the shift lever cover from the lining.
Remove front seats.
Remove front center console (station wagon).
Depending on the vehicle equipment, remove the storage compartment from the center console (1) or storage compartment (2).
Open the cup holder and remove the screw (3) (1.5 Nm).
Remove the cup holder from the center console.
Opening the armrest, unlock the two latches (arrows) and remove deflector (1) from the center console.
Remove the screw (2) (1.5 Nm) and remove the trim (3) center console.
Disconnect the electrical harness (5) from the socket (4).
Remove two screws (1) (1.5 Nm).
Remove two screws (2) (1.5 Nm).
Remove two screws (3) (1.5 Nm).
When assembling, install the screws in the same sequence.
Open the side walls of the center console and remove the insert (4).
Remove mats (1) from coasters.
Remove two screws (2) (1.5 Nm).
Install shift lever (gear selector) to the extreme forward position.
Pull apart the side walls (arrows) and remove the upper part of the center console from the vehicle.
Remove two screws (1) (1.5 Nm).
Unscrew the nuts on both sides of the rear frame of the center console (2) (4.5 Nm) and remove washers (3).
When assembling, screw in the screws first (1) and then tighten the screws (2).
Remove the screws (1) And (2) (1.5 Nm).
Remove rear center console frame (3) from the car.
Remove two screws (1) (1.5 Nm).
Remove the screw (2) (1.5 Nm).
Remove center console frame (3) from the car.
Visitor comments