Fig. 12.58. Heater in disassembled state:
1 - Heater radiator; 2, 5, 8 - Screws; 3 - Air distributor; 4 - Fresh air/air recirculation drive; 6 - Heater fan; 7 - Series resistor; 9 - Central damper lever; 10 - Temperature control lever; 11 - Main plate; 12 - Seal.
Installing and adjusting the lever for the central damper
The central flap gear has adjustment marks (fig. 12.59). Position the lever so that the mark on the lever and the mark on the gear are aligned (arrows).
Installation position of the heater radiator/engine compartment bulkhead seal
The seal between the heater radiator and the engine compartment bulkhead has alignment marks. Install the seal 1 so that the alignment mark on the seal and the mark on the main plate 2 are aligned 3 (fig. 12.60).
Visitor comments